chanelink logo
CHANELINK
Français

Active job is running LED

Catégories:
Laser
Tags:
843
1
Voir la traduction
2023-11-10

Hello, I would like to put a blinking led before the door, when the laser is running.
Is there an idea here, how to control a relais, when lightburn is running?
Thanks.
C

    • Payson

      2023-11-11
      If you put a LED in parallel with your laser pwm signal you can know if the laser is active and potentially dangerous. The problem as I see it, is there isn’t an obvious way to know if the engraver is about to become dangerous.
Remaining near your engraver while it is active is a safety requirement.
        Voir la traduction
        Répondre
      Recommandations pertinentes
      Collecter
      Rapport