chanelink logo
CHANELINK
Français

Laser fibre 3d ezcad3

Catégories:
Laser
Tags:
815
1
Voir la traduction
2023-07-31

Hello I will receive a laser fiber jpt 50w 3d with motherboard 3D G3 series BJJCZ controller I would like to know if I can use lightburn for this one even if it is not in 3d but at least for “normal” engravings and if lightburn plans to support 3d fiber lasers?
C

    • Clarence

      2023-08-01
      The EZCad3 software and controller are different from EZCad2 and that control board. At the time it’s not supported… Sorry… you would have to go to an EZCad2 board…
        Voir la traduction
        Répondre
      Recommandations pertinentes
      Collecter
      Rapport