chanelink logo
CHANELINK
Français

MKS DLC32 error:20

Catégories:
激光
Tags:
923
1
Voir la traduction
2023-07-28

Lightburn MKS DLC32 error:20

I am using an MKS DLC32 and am getting the error code error:20

With gbrl everything works fine, but with Lightburn it doesn’t go well.

The machine is steering with the controls. The fire is also on. But when I start it, the machine draws 1 line and the laser does not turn on.

Is there a solution

Jan Postema
C

    • Tory

      2023-07-31
      Check to make sure your device is set up with the correct device profile, following these steps:

-Click ‘Devices’ in the ‘Laser’ window
-Double click your laser in the list
-Make sure the selected device is set to ‘GRBL’
-click next until you’re done

Next, in your Device Settings (‘Edit’ > ‘Device Settings’), make sure you do not have ‘GCode Clustering’ enabled.
        Voir la traduction
        Répondre
      Recommandations pertinentes
      Collecter
      Rapport