chanelink logo
CHANELINK
Français

Project Time Estimate Way Off

Catégories:
Laser
Tags:
935
1
Voir la traduction
2023-05-31

I’ve looked over this site and online and can’t seem to find the specific methodology for tweaking Additional Settings in Device Settings to get my project time estimate a lot closer to reality then what currently exists. Yes, I have clicked on read from controller - but that didn’t help time estimates at all. Does anyone have any information on how to tweak the various items/settings in Additional Settings?
C

    • Robert Evans

      2023-06-01
      Hi Jimbo - you can use that figure to adjust the ‘Cut Speed Scale’ and ‘Global Speed Scale’ entries in the Simulation Settings window. If your review estimate is approximately half the speed you expect, then set the global value to 200%
        Voir la traduction
        Répondre
      Recommandations pertinentes
      Collecter
      Rapport