chanelink logo
CHANELINK
Français

Help with engraving Images

Catégories:
Laser
Tags:
908
1
Voir la traduction
2023-05-26

I cannot get lightburn to engrave an image. If I use GRBL it will engrave no problem. In lightburn I get a gcode error. Any help would be great. Thanks, Dave
C

    • Jamie

      2023-05-27
      G90
; GCode clustering enabled (max 8)
G4 P1
M4

Some engravers do not have ‘clustering’.

Click Edit, then click Device Settings… Turn off the ‘Enable GCode Clustering’ switch… Then Carefully click ok at the bottom. We really want to make sure the setting stays put.
      Voir la traduction
      Répondre
    Recommandations pertinentes
    Collecter
    Rapport