My fiber laser cutting machine has changed its control card: RDC6563FG. Today, when I was operating it in manual mode, the XY axis did not move. I know this is a typical motion control problem, so how should I adjust it?
¿Puedes responder esta pregunta?
Escribe tu respuesta para ayudar a quienes tengan la misma duda.
Respuesta aceptadaThe following steps can be taken, hoping to be helpful to you
1. Refer to the relevant wiring instructions in the user manual for correct wiring
2. Set parameters correctly according to the servo drive manual
3. Correctly set limit polarity
4. Re power on the servo to eliminate the alarm
¿Tienes una pregunta similar pero no encuentras solución? Publica tu propia pregunta y recibe ayuda de la comunidad.
Copyright © 2021 Shenzhen Chanelink Network Technology Co., Ltd. All Rights Reserved.
As you said, my servo drive parameter settings were incorrect and have been corrected. The machine is now running normally. Thank you, Roy