chanelink logo
CHANELINK
Español

Not Marking

Categorías:
Láser
Etiquetas:
1K
1
Ver traducción
2023-02-24

I have MP-30 LiteMarker 30W Split Laser Engraver… I have EZCAD 2 and have installed the driver just fine. I have adjusted the focus. I have used the EZCAD 2 that was shipped with the laser.
C

    • Payson

      2023-02-27
      1. Check if all buttons are turned on
2. Check whether the driver is connected correctly
3. Check parameter settings, output or fill
4. Turn the rotary wheel up and down to check whether there is laser emission
        Ver traducción
        Responder
      Recomendaciones relevantes
      Recoger
      Informe