chanelink logo
CHANELINK
Español

Laser cutting of acrylic with rough edges

Categorías:
Laser
Etiquetas:
350
1
Ver traducción
09-29
Hello, I am cutting extruded acrylic and the edges are very rough and appear to have little bubbles through out it. I've cut this stuff before with a great flame polished finish. Any advice on why this is happening?
C

    • Williams

      09-30
      Have you tried lowering the amount of air assist you are using? Too much and it will cool the cutting zone.
        Ver traducción
        Responder
      Recomendaciones relevantes
      Recoger
      Informe