The stepper motor has resonance issues

Noah

Categorías:

馬達

Etiquetas:

648

Ver traducción

04-02

I am having some problems with the noise and grinding from the x-axis. Soundls like mad cow disease! I am using an 17HS24-2104S STEPPER with a DM542T driver. Can not find a smooth setting. Per sepperonline I have added a resonance mount with rubber cushion and it is a considerable amount quieter but still bad.

Aaron

04-07
```
I usually change my speed a little.
```
Ver traducción

0

Responder
- Noah
  
  : I have tried several speeds. Weird but the y axis is great.
Cyril

04-09
```
Just a long shot…
but check the driver setting (if any)
make sure they are set to the the recommended by the manufacturer..

this is my system , it has the dip sw setting that are recommended on the stepper motor…

Long shot but, if it gets changed… could be an issue…
```
Ver traducción

0

Responder
- Noah
  
  : I just swapped wiring on x an y and no change. So I looked at some spar stepper motors and the were smoother turning by hand. So I replaced the motor and the x-axis is near perfectly quiet! Wonderful. I have been working on this motor forever.