Origin readings Y-390 and X-279

LWE

Categorías:

Láser

Etiquetas:

795

Ver traducción

03-03

I have a Fox Alien Vasto CNC. The machine homes to the bottom left corner and in light burn it puts the laser in Y -390 and X -279. I have no problem burning or cutting projects because I align my projects with the laser off of the work area and it runs fine. But I have added a camera to help me align projects and when I try and align the camera it puts the graphics to burn to help align the camera in side the work area and when I run the program it sends the machine right into the limit switch’s. Can you adjust the work area to where the machine homes?

John Trant

03-04
```
Try enabling CNC mode
```
Ver traducción

0

Responder
- LWE
  
  : thank you for replying. I turned on cnc and it put the origin just the opposite in the positive. If I change the origin between top right and bottom left the laser position does just the opposite.
Keegan

03-06
```
Enter G10 L2 P1 X-279 Y-390 in the Console window. This should tell your machine to operate in the first quadrant, which is where Lightburn is happy.
```
Ver traducción

0

Responder
- LWE
  
  : Thank you for your help. I’m a little new to this so bare with me, when you say console window you mean in light burn where you type commands?
- Keegan
  Responder
  @LWE
  
  : That is correct.