chanelink logo
CHANELINK
Español

RDC6563FG

Categorías:
Ruida
525
5
Ver traducción
02-26
Hello.
I have RDC 6563FG, laser MAX 1500, BM-110 head and two X-Y axes.
I need to place the metal plate at a distance of more than 30 mm from the nozzle and process it with a defocused laser beam.
Is it possible to disable the use of the capacitive sensor and not monitor the gap between the metal plate and the nozzle? Otherwise, the message appears - <too small cap>.
C

    • blue sea

      02-28
      Hello! You can choose not to follow in the layer settings to disable it.
        Ver traducción
        Responder

      • A56F72A7

        02-28
        In this case, the graphics are processed without turning on the laser radiation.
          Ver traducción
          Responder

        • A56F72A7

          03-04
          The issue is resolved. The shutter had to be pressed before the start
            Ver traducción
            Responder

          • A56F72A7

            03-06
            One more question. Why is the "Machine Check" button not active in RdCutist v3.0?
              Ver traducción
              Responder
              • blue sea

                : Hello, this function is not yet open for use, the software is constantly being tested and optimized, please pay attention to the latest notice on our official website in the future, thank you for your support and use!

            Recomendaciones relevantes
            Recoger
            Informe