The starting and ending positions are different

Noah

Categorías:

Láser

Etiquetas:

Laser cutting
Laser marking

969

Ver traducción

2024-10-11

So when I engrave or cut the laser moves to the same position it starts from. When I use the rotary and engrave tumblers the laser head goes to a differant position from where it starts. This has changed since I upgraded from 1.6 to 1.7.01. How do I change so laser head parks after engraving in the same position it starts?

Cyril

2024-10-12
```
Check if you have this option selected.
```
Ver traducción

0

Responder
- Noah
  
  : not sure if return to finish should be checked or not… I have always used " Currant position"
- Cyril
  Responder
  @Noah
  
  : You need to select “Return to Finish Position” if you intend to park the laser head in a certain location. That location is set below on “X” and “Y”