chanelink logo
CHANELINK
Español

Air Assist stopped working

Categorías:
Láser
739
2
Ver traducción
2024-09-23
Can anyone help with auto air assist, I upgraded motherboard Atom stack to allow auto air on/off, it worked perfectly untill the last Light burn update, the on/off button in the cuts/layers is set ot on, is there something in the background that needs setting.
C

    • Kevin

      2024-09-24
      It is most likely the air pump went bad, the power supply for the pump went bad, or the connector came loose. Not a software problem.
        Ver traducción
        Responder

      • Gilbert

        2024-09-25
        You need to set up the correct M Value in Lightburn. It is either M07 or M08. It is somewhere in the settings of Lightburn. To test it, just type in the console window M07 or M08 and check which one activates it. M09 switches it off again.
          Ver traducción
          Responder
        Recomendaciones relevantes
        Recoger
        Informe