Raytools BM110 Autofocus - A axis reset fail

Juan Barkhuizen

Categorías:

Ruida

777

Ver traducción

2024-07-21

This error happens everytime I power on the laser, I have confirmed by opening the laser that the laser autofocus is working, doing a manual A axis reset works perfectly but as soon as I enable Focus Ctrl in A axis vendor setting I get "A axis reset fail" each time the laser powers on. Can anyone help?

Controller : Ruida RDC6563FG-Lite
Laser Head : Raytools BM110 Chinese Ver

Snow Sun

2024-07-23
```
check if the limit switch is PNP or not. our controller only support NPN type.
Mostly this error happend when the limit switch can not be found
```
Ver traducción

1

Responder
- Juan Barkhuizen
  
  : There is no issue with the Limit switches, they show up in Diagnoses and doing homing or axis reset gives no errors. I can see the autofocus move when I reset it, It goes from 0 to -15 then resets back to zero. This issue happens each time I switch the machine on, it asks me if the machine is reset, then it gives this error after that. Manual move works, and software control also works no issues. I am not sure why I get this error still