G code error,Problem with engraving a photo

roy

Categorías:

Láser

Etiquetas:

LightBurn

689

Ver traducción

2024-01-18

Problem with engraving a photo, laser starts in lightburn software and then freezes, don’t know where to look for the cause. Anyone have some idea? Photo of error

Liam

2024-01-19

Disable Gcode Clustering
AS far as i know Neje does not support it
Should fix the issue
Also, does your NEJE have Z axis (up and down)? If not, disable those as well (top right corner)

Ver traducción

Responder

Recomendaciones relevantes