chanelink logo
CHANELINK
Español

Ortur LM3 X axis vs Y axis cutting power

Categorías:
レーザ
Etiquetas:
205
1
Ver traducción
2023-12-18

Im using a LM3 with a 10 w laser and having issues with X axis cutting deeper than the Y axis. This happens on wood, leather and cardboard. It also happens when using the Materials Test in Laser Tools.
Any help would be appreciated !

LightBurn
C

    • David

      2023-12-22
      The dot sizes on most diode lasers are not symmetrical
X and Y are normally of different sizes.
Meaning they will perform slightly different
In this case your dot size is a little rectagle. Thinner on the X. thicker on the Y
You nee to adjust power for the thicker dot side
        Ver traducción
        Responder
      Recomendaciones relevantes
      Recoger
      Informe