Speed and Power settings not being saved in .nc file [AtomStack x20 Pro]

Liam

Categorías:

Láser

Etiquetas:

LightBurn

699

Ver traducción

2023-09-08

I’ve just started playing around with Lightburn and my new Atomstack X20 Pro.
I created a design to engrave, and set the speed and power in the Cuts/Layer tab, and then saved the .nc file. I transfer the file to a thumb drive (with a TF card) and insert it’s TF card into the Atomstak.
However, when I open the file and start the engraving, the little hand-held terminal/control says it’s using 100% Power and Speed.
Is there something else I need to do to get these settings to apply?
Is there a way to see if they are in the g-code (or add it manually)?
Thanks!

Jamie

2023-09-11

"This is a vector object? then draw a piece that reachs both ends, and boolean them together…"

It’s likely that whatever the configured speed is in gcode will show as 100%. The percentage may be meant to show changes from base (100%) using on-screen overrides.
Test that the speeds for engraving are indeed changing by making one with very slow speed and one with very high speed. The difference should be apparent.

Ver traducción

Responder

Recomendaciones relevantes