chanelink logo
CHANELINK
Español

EZcad3 future compatibility

Categorías:
Láser
Etiquetas:
949
1
Ver traducción
2023-08-01

Hey everyone. Has anybody heard anything about future use with EZcad3 and any time frames. I’m in a bit of a pickle right now cuz EZcad3 is acting very strange. And before downgrading to EZcad2, I want to make sure. I sure do like the auto Z axis and don’t want to give that up if I don’t need to. Thanks all.
C

    • Jen

      2023-08-02
      I thought the two were not compatible with each other, controller wise… I believe the EZCad3 board is different from EZCad2… I’m thinking you can’t run EZCad2 on it… but you can advise us…
As far as I know they are looking at it, but I haven’t head much in quite a while about Z axes support with this other controller.
        Ver traducción
        Responder
      Recomendaciones relevantes
      Recoger
      Informe