Problem setting Rotary attachment for C02 laser

Liam

Categorías:

Láser

Etiquetas:

LightBurn

751

Ver traducción

2023-07-03

Hi Guys,
I’m in process of trying to setup a rotary attachment on my 700x500 Red and black laser and I’ve encountered a problem.
So I’ve disconnected Y axis and connected rotary attachment. The rollers move when i hit the up and down which as i understand is correct. I’ve then enabled rotary in lightburn and Y axis is selected in rotary axis and filled in all the relevent required information in regards to steps, job diameter etc. When i hit the test button however the X axis moves, not the rotary attachment (ie Y axis) .Anybody have an idea what i’ve done wrong?
Thanks in advance Cleeve Costin

Jen

2023-07-04

It’s possible that your controller is configured to use U-axis for rotary. Try setting that in the Rotary Setup window and see if that works.
Note that it’s possible the test button and framing function may not work with U-axis.

Ver traducción

Responder

Recomendaciones relevantes