Transfer camera settings to “New” laser

Christian

Categorías:

Láser

Etiquetas:

LightBurn

329

Ver traducción

2023-07-03

I changed the connection of my Omtech Polar 350 from USB to Ethernet. Now the camera view is distorted. I would like to somehow get the camera settings from the USB profile and transfer them to the Ethernet profile. Where are these settings stored? in the preferences or ini files? These are backed up so I could use them to cook something up, if I only knew which sections to cut and paste from one to the other.
Any suggestions are appreciated. I sure don’t want to have to set up the camera again…
Thanks for your help.

Robert Evans

2023-07-04

Is it possible that the lid isn’t fully closed or that the camera was bumped while making this change?
If you import an early set of preferences (File > Import Prefs) you can get the camera information back into LightBurn. Then you can change the communications settings to what you have now, you should be back to an undistorted camera - unless you bumped it.

Ver traducción

Responder

Recomendaciones relevantes