Pits/holes in glass around edges

Clarence

Categorías:

Láser

Etiquetas:

LightBurn

864

Ver traducción

2023-06-12

Does anyone know why I am getting these pits, or random holes in the image and around the edge of my image in the glass?
Settings are: Xtool D1 20w, Speed 7500, power 75% Bi-directional pattern, Line interval 0.100 mm, lines per inch 254.0, number of passes 1.

Vasili

2023-06-13

I use lbt100 spray for the co2, when I tried it with my ss laser, it didn’t work out too well… My communications with them was it was made for co2, not ss led type lasers…
I think both Cermark and LBT100 are about the same type/kind of spray.
Can you scrape it off? That would indicate it isn’t bonding to the material properly… Have you used it before with good results?

Ver traducción

Responder

Recomendaciones relevantes