Help with engraving Images

Liam

Categorías:

Láser

Etiquetas:

LightBurn

252

Ver traducción

2023-05-26

I cannot get lightburn to engrave an image. If I use GRBL it will engrave no problem. In lightburn I get a gcode error. Any help would be great. Thanks, Dave

Jamie

2023-05-27

G90
; GCode clustering enabled (max 8)
G4 P1
M4

Some engravers do not have ‘clustering’.

Click Edit, then click Device Settings… Turn off the ‘Enable GCode Clustering’ switch… Then Carefully click ok at the bottom. We really want to make sure the setting stays put.

Ver traducción

Responder

Recomendaciones relevantes