chanelink logo
CHANELINK
Español

New to lightburn and dont know how i would engrave this

Categorías:
Láser
Etiquetas:
935
1
Ver traducción
2023-05-24

how should one go about making outlines? so for the green lines, i thought i could just use the option “fill” but that resulted in the whole picture getting engraved. i really wanna make big outlines, but i dont know how to do it.
C

    • Keegan

      2023-05-25
      Put the inner and outer shapes representing the outline on the same layer and use fill.
        Ver traducción
        Responder
      Recomendaciones relevantes
      Recoger
      Informe