Double line cutting on atomstack M100 / E85 module

Liam

Categorías:

Laser

Etiquetas:

LightBurn

Ver traducción

2023-05-24

Hello everyone, I am having a double-line issue. I have already adjusted both axis, but the problem persists.-
What i find strange is that all the double lines go in the same way, and they al seem perfectly cut and seems like a pattern and not linke an error.
Any advises? Is it a harware issue?
Thank you all in advance.

Keegan

2023-05-25

How have you done this?
To me it looks like you may be missing steps on the X-axis. Check belt tension and make sure you’re not skipping the belt. Also check that the pinion gear is properly secured to the stepper shaft.

Ver traducción

Responder

Recomendaciones relevantes