chanelink logo
CHANELINK
Español

When print is finished - X is dont stop

Categorías:
Láser
Etiquetas:
1.1K
1
Ver traducción
2023-05-08

Hello. have Sculpfun S10 without endstops
When lightburn is finished with the burn, it backs about 15cm, and parks into the wall (“Ratschhh”), not good.
I want it to stop immediately. How do I?
i use “absolute coords -mode”
C

    • Darren

      2023-05-09
      Disable “Return to Finish Position” in Edit->Device Settings.
        Ver traducción
        Responder
      Recomendaciones relevantes
      Recoger
      Informe