RECI W2 CO2 laser tube power settings

There is a setup procedure that I have found very functional but involves setting the lps via an internal pot. There is usually a hole in the lps that allows you to adjust it.
The procedure is to send a 50% pwm (power) or use the console to set it and manually pulse it in continuous mode.
If your 100% is 24mA, you set the pot for 12mA. This 50% control settings makes sure you don’t overdrive the tube during this setup procedure…
You have set the 50% pwm to cause 12mA to flow… In Lightburn a 50% power setting will result in a 12mA current flow… everything syncs up with the software…
The pot on mine requires a contortionist to adjust… this is from the back of the machine…