chanelink logo
CHANELINK
Español

Missed lines in hatch fill

Categorías:
Láser
Etiquetas:
901
1
Ver traducción
2023-03-09

When I am engraving, I notice that there are missed lines in the text that have not been engraved, they follow the hatch direction. I also use crosshatch and it is still there. I engrave stainless steel and within all the text there are these silver lines. Any ideas. I used a 0.001 hatch.

 
C

    • Snow Sun

      2023-03-10
      Which software did you use? if it is RDWorksV8, it should be not happend with such situation. just se the hatch interval correctly in the layer parameter and set the mode to be scan mode.
if it is LB, you can set 0.02 or more to check.
        Ver traducción
        Responder
      Recomendaciones relevantes
      Recoger
      Informe