Cloudray 80W 115/230V MYJG

Most of these lps have an internal adjustment for current limiting. On mine, you have to be a contortionist to reach the adjustment…
This is mine, viewed from the rear, the Ruida machine console it at the far back top of the photo…

I was advised on mine to set a 50% pwm signal and adjust the current to 50% of maximum you wish to run.
Once adjusted, it will produce 50% current with a 50% power level setting in the software.
My maximum was specified at 21mA, so I set 50% pwm for 10.5mA…
Good luck