chanelink logo
CHANELINK
Ελληνικά

CO2 laser gets weaker above 50%

Κατηγορίες:
Λέιζερ
Ετικέτες:
1.2K
1
Δείτε τη μετάφραση
2023-02-27

My 40-50W co2 laser cuts 1/4" plywood and acrylic well at 50% but above 50%, the cuts get shallower as I increase the power. The current stays approximately proportional to the power setting, but the beam seems to get weeker. Is this normal or a sign of a partucular failure?
The tube has less than 100 cutting hours, mostly at about 45%. I almost never run above 15mA current.
The tube is a TONGLI 40-50W Co2 Laser Tube
35-50W CO2 MYJG Serise Power Supply MYJG-40 OG 110/220V × 1
C

    • Cyril

      2023-02-28
      Check if your laser mirror alignment is spot-on. It could be that when you increase the power, that the beam gets reflected within the side of the laser head tube and is not 100% leaving your laser head. If you increase the power, thus the tube (at the laser head) getting warm/hot?
        Δείτε τη μετάφραση
        Απάντηση
      Σχετικές συστάσεις
      Συλλογή
      Αναφορά