chanelink logo
CHANELINK
Ελληνικά

6563F moves manually on the panel according to Z-axis, and the cutting head does not move.

Κατηγορίες:
Ruida
Ετικέτες:
846
2
Δείτε τη μετάφραση
2023-01-05

6563F moves manually on the panel according to Z-axis, and the cutting head does not move.
C

    • Jamie

      2023-01-06
      Analysis and troubleshooting:
① The wiring of the servo driver is incorrect.
② The servo driver parameters are not set correctly.
③ The servo driver does not support speed control mode.
④ The Z-axis of the mainboard gives an alarm, causing the movement to stop.
⑤ The connection between the panel and the motherboard is abnormal.
        Δείτε τη μετάφραση
        Απάντηση
        • Jamie

          : Solution: ① Refer to the relevant wiring instructions in the user manual for correct wiring. ② Set the parameters correctly according to the instructions of the servo driver. ③ Please select a drive that supports speed control mode. ④ Eliminate the alarm fault according to the alarm prompt on the panel interface. ⑤ Check whether the panel connecting line is firm, and the Z-axis movement can be controlled through PC.

      Σχετικές συστάσεις
      Συλλογή
      Αναφορά