chanelink logo
CHANELINK
Ελληνικά

Z-axis does not move upward during homing

Κατηγορίες:
Λέιζερ
657
5
Δείτε τη μετάφραση
2024-11-08
I have an Atomstack A70 with a movable z axis, the issue is that when I home the machine the z axis does not move up. I can move it with the move buttons and with a z home macro $HZ. The x and y axis home as they should. Thanks.
C

    • Payson

      2024-11-09
      That’s defined in the firmware. There is no setting to change this from the outside. You would need a new firmware then (at least if Atomstack didn’t invent a new firmware setting to configure that).
        Δείτε τη μετάφραση
        Απάντηση

      • Henry

        2024-11-11
        You could try this at your own risk. Works for dlc32 controller.
The command to turn on this feature: ($Homing/Cycle1=Z)or($Homing/Cycle0=Z;$Homing/Cycle1=XY)
The command to turn off this feature: $Homing/Cycle1=0
          Δείτε τη μετάφραση
          Απάντηση
          • 55455rml

            : I assume I type this in the console and it will then be a permanent part of the gcode for the machine? As I am sure you can tell this is new to me so I appreciate your help.

          • Henry
            Απάντηση
            @55455rml

            : I don’t know what controller you have. For the dlc32 I had the Z was disabled and entering $homing/cycle0=z and then $homing/cycle1=xy enabled the Z axis during homing.

          • 55455rml
            Απάντηση
            @Henry

            : I tried putting these in the console and in the start gcode/end gcode under the gcode tab of device settings and it didn’t change anything.

        Σχετικές συστάσεις
        Συλλογή
        Αναφορά