chanelink logo
CHANELINK
Ελληνικά

How to disable Constant Power Mode

Κατηγορίες:
激光
Ετικέτες:
796
1
Δείτε τη μετάφραση
2024-01-06

I upgraded from the stock Yorahome controller to a MKS DLC32 controller. When using the original controller I ran an engrave test that used the power scaling and it worked great. Now that I switched to the DLC32 and open the same file, the constant power mode it turned on.
I am sure I messed up something in the settings and need help locating the default setting to turn this off by default.
C

    • Liam

      2024-01-08
      1. Disable Constant Power mode in Cut Setting
2. Then click “Make Default” or “Make Default for All” depending on what you want
        Δείτε τη μετάφραση
        Απάντηση
      Σχετικές συστάσεις
      Συλλογή
      Αναφορά