Latest update - jogging direction reversed

Abel

Κατηγορίες:

Laser

Ετικέτες:

LightBurn

609

Δείτε τη μετάφραση

2023-12-12

Just updated Lightburn (not used it for months while moving from one location to another). The version I downloaded is 1.4.04 running on Mac Os Big Sur version 11.7.10. Homing is correct. Z direction is correct. Jogging in X or Y direction is wong. Both directions are opposite to the expected. I engraved a project and the laser worked fine. The image was upside down though. Any advice on a setting to change would be welcome. Thank you.

Darren

2023-12-13

Your Origin setting in Edit->Device Settings is almost certainly incorrect. If both mirrored and flipped then put Origin to opposite corner. But more than likely your machine is intended to work in bottom-left origin.

Δείτε τη μετάφραση

Απάντηση

Σχετικές συστάσεις