chanelink logo
CHANELINK
Ελληνικά

Drawing in program doesn’t match finished engraved one

Κατηγορίες:
Λέιζερ
Ετικέτες:
563
1
Δείτε τη μετάφραση
2023-09-20

Hi im using lightburn 1.4.01 and im having an issue with the size on screen vs finished product.
if i draw a 50x50 mm square its ok on screen but when finished the width is exactly 50mm but the height is 114.5mm and a 40x40 is the same with is correct but height is 91mm
i have attached a picture below of this,what am i missing here to fix this ?
Thanks

LightBurn
C

    • Jen

      2023-09-21
      Do you have Rotary mode enabled in LightBurn? If so, disable and retry.
        Δείτε τη μετάφραση
        Απάντηση
      Σχετικές συστάσεις
      Συλλογή
      Αναφορά