Limit issues, even after frameing

You’re likely not meeting one or both of the following conditions:
Homing the laser prior to session. Your machine likely doesn’t have homing sensors although some people report successfully being able to use sensorless homing with that machine. If sensorless homing does not work then you should be manually homing by turning on the machine with the laser head at top-left.
Using jogging controls exclusively after homing. Avoid moving the laser module by hand at any point after homing.
Do not ignore any warnings about going out of bounds
If these conditions are met you should never have a crash in LightBurn assuming machine configuration is basically correct.