chanelink logo
CHANELINK
Ελληνικά

Zooming too fast

Κατηγορίες:
Λέιζερ
Ετικέτες:
987
1
Δείτε τη μετάφραση
2023-09-07

After loading an image into lightburn, I should be able to hold the shift key and roll my mouse wheel to zoom in or out. As soon as I move the nouse wheel, my image immediately becomes small, then tiny. Then I have to start over again by importing image back into lightburn. Not sure why this happens. It may be the mouse/computer. I have an x-tool non pro 10 watt D1. Would appreciate any feedback on this.
C

    • jessie

      2023-09-08
      Note that shift key shouldn’t be required for this to work. Mouse wheel alone should zoom in and out.
Mice can have configurable scroll magnitude, either in hardware, software, or both. First check that the hardware has configurability. If not, go to mouse settings and change “Lines to scroll at a time” or “Roll the mouse wheel to scroll” or something similar to change behavior.
        Δείτε τη μετάφραση
        Απάντηση
      Σχετικές συστάσεις
      Συλλογή
      Αναφορά