chanelink logo
CHANELINK
Ελληνικά

Laser settings changed while working on a project

Κατηγορίες:
Λέιζερ
Ετικέτες:
1.1K
1
Δείτε τη μετάφραση
2023-08-11

I was cutting and engraving 1/8 ply when my settings changed from 90/20 to .3/55. Cutting and engraving speeds are all less than 10mm/s. I have reloaded the cut library and redownloaded one as well. Still nothing. It changed all of the settings in the library with speeds starting 0.xxx. Any advice is appreciated.
C

    • Christian

      2023-08-14
      It looks like your units have switched into inches/sec, which explains the difference in speeds displayed. Try going into your LightBurn settings and switching to mm/sec.
      Δείτε τη μετάφραση
      Απάντηση
    Σχετικές συστάσεις
    Συλλογή
    Αναφορά