chanelink logo
CHANELINK
Ελληνικά

Air assist pause

Κατηγορίες:
Λέιζερ
Ετικέτες:
965
1
Δείτε τη μετάφραση
2023-07-08

Have a compressor set up which takes 30s to build pressure on first power on. Using m8 to turn on. And off a demand valve and if I get m8 I ensure compressor is on. (small logo plc runs compressor).

So question is if on change of layer can I get a pause after the m8 comes on (for the first time} so compressor can build pressure, once pressure is up compressor will remain, on for 20mins so not an issue through rest of layer… Dont want a a pause at every time m8 goes high only first time.

I assume a macro should be able to do this or a bit of gcode… Bit like this

If air assist=on then
m8
wait 30s
start cut
Else
Start engrave
End if
C

    • Keegan

      2023-07-10
      G4 P30

The LinuxCNC spec for G4, which is where GRBL started, says the units are seconds. Some forks use milliseconds, so if it doesn’t seem to pause, try multiplying by 1000:

G4 P30000
        Δείτε τη μετάφραση
        Απάντηση
      Σχετικές συστάσεις
      Συλλογή
      Αναφορά