chanelink logo
CHANELINK
Ελληνικά

Air Assist - what downside to running it throughout the project

Κατηγορίες:
Laser
Ετικέτες:
840
1
Δείτε τη μετάφραση
2023-06-16

Hi there, I’m new to laser work and Lightburn. Using second hand a LaserMaster 2. I was told to use the air assist when ctting. I can understand why this needs to be used.If I were to leave the air pump running even while burning lines what effect would it have on the outcome? I can’t work outwhat downside its to running it for the whole project.
C

    • Patrick

      2023-06-19
      The air assist serves two purposes: blow the smoke away from the part to reduce discoloration, and to blow the smoke away from the laser lens. That implies leaving it on all the time (for all layers).
        Δείτε τη μετάφραση
        Απάντηση
      Σχετικές συστάσεις
      Συλλογή
      Αναφορά