chanelink logo
CHANELINK
Ελληνικά

Compatibility between lightburn and the RNR Ecomotion board

Κατηγορίες:
Laser
Ετικέτες:
909
1
Δείτε τη μετάφραση
2023-05-26

Good morning,
I am building a homemade 60w CO2 laser machine and I would like to know if ligthburn is compatible with the RNR ecomotion board.
If so, I can create and run g-code inside lightburn, without needing mach3, correct?
And i need some special driver?
Thanks a lot for the help.
C

    • Henry

      2023-05-27
      If it runs Mach3 today then no, it’s almost certainly not compatible with LightBurn. You may be able to generate gcode that could be run in Mach3 but no certainty in that and you’d likely need to modify the gcode in some way.
        Δείτε τη μετάφραση
        Απάντηση
      Σχετικές συστάσεις
      Συλλογή
      Αναφορά