chanelink logo
CHANELINK
Ελληνικά

Fast Whitespace Scan not working

Κατηγορίες:
Λέιζερ
Ετικέτες:
936
1
Δείτε τη μετάφραση
2023-05-26

If I enable this setting and set it to a high number, the preview shows a reduced processing time, but I’m not seeing anything speed up when the job is actually processing. It completes in the same amount of time as it did before. Does this function not work for gcode lasers? I have an xTools at the moment.

Thanks.
C

    • Jamie

      2023-05-27
      You cannot go any faster than the highest maximum speed defined in your firmware. Once you exceed that your machine won’t go any faster but Preview is unaware of your machine’s limitations.
        Δείτε τη μετάφραση
        Απάντηση
      Σχετικές συστάσεις
      Συλλογή
      Αναφορά