chanelink logo
CHANELINK
Ελληνικά

Count And Passes

Κατηγορίες:
Lazer
Ετικέτες:
788
2
Δείτε τη μετάφραση
2023-04-27

Hi. I have my cut/layers set up with two layers to be marked: one clean-up pass and one for depth. I have both layers set to do 5 passes at a 45 scan angle with angle increments of 72.
If I enter “25” for the count on the laser screen, it does 25 of my first layer and then 25 of my second layer rather than doing 5 passes of each alternating 25 times. How can I set it up to do the alternating passes for 25 counts?

 
C

    • Robert Evans

      2023-04-28
      Where are you entering these? In the layer, I assume…
      Δείτε τη μετάφραση
      Απάντηση
      • Robert Evans

        : I do this using the live framing screen for the fiber… if you set your passes in the above for 5 and 5, then use the live framing to set the count to 25, it will loop through the job that many times… You have to reset the count and enable repeat. I think if you close this window, it will stop once the current job has been processed… See if this helps you do what you want…

    Σχετικές συστάσεις
    Συλλογή
    Αναφορά