chanelink logo
CHANELINK
Ελληνικά

Wobble setting not cutting along original line

Κατηγορίες:
レーザ
Ετικέτες:
508
1
Δείτε τη μετάφραση
2023-03-08

Hi everyone. I’m having an issue in Lightburn when enabling the wobble effect setting. The issue is that the wobble isn’t cutting along the original path line, but rather gravitating toward the bottom of the cut. If I’m not mistaken, the wobble effect must run along the original path line equidistantly.

 

Please see the photo: The original cut line is the circle and you’ll notice that the wobble is not moving along the original path.
Anyone have a solution?
C

    • Smith

      2023-03-09
      What’s actually happening is that the beam is never turned off during wobble runs, and the end point of each circle is connecting to the start point of the next.

If you draw a “circle of circles” and connect the TOP point of every circle to the next one in the sequence, you’ll get your output. If you add a second pass to your line layer, with the wobble setting turned off, you’ll see that it makes a single line straight through the center of all the “wobble” circles.
        Δείτε τη μετάφραση
        Απάντηση
      Σχετικές συστάσεις
      Συλλογή
      Αναφορά