There is a problem sending data to the laser
Hello,
I also have the problem that when transferring data I get the error message that an error occurred while sending (the device may be busy or stopped).
In the forum I found a post that you can try to set "enable DTR signal" in the device settings.
Where exactly can I select this in the device settings?
I also have the problem that when transferring data I get the error message that an error occurred while sending (the device may be busy or stopped).
In the forum I found a post that you can try to set "enable DTR signal" in the device settings.
Where exactly can I select this in the device settings?
Was halten Sie von diesem Beitrag? Teilen Sie Ihre Gedanken in den Kommentaren.
Here’s where the enable DTR signal is located in device settings.