RDC6445G Tri-color Lamp
Hi all,
I've just completed building a 600mm x 400mm 90w machine with an RDC6445G controller.
I noticed (in the manual) that a tri-color warning lamp can be connected to the controller but I'm unsure how to do this. I did see a video on YouTube where a single lamp was connected to the 'Status' pin but I would like a three-color lamp (as shown in the manual). How does this connect to the controller?
Was halten Sie von diesem Beitrag? Teilen Sie Ihre Gedanken in den Kommentaren.
Hello, you can connect the STA port to the green light, the OUT1 port to the yellow light, the OUT2 port to the red light to connect, thank you for your support of Ruida products!