Camera Overlay square in every corner except one
Kategorien:
Laser
743
1
0
2024-01-08
C
Henry
2024-01-09Try to get the camera more square to the frame and orthogonal to the bed. Additionally you may need to raise the height of the camera. This will require you to go through camera alignment again if you change position or orientation of the camera.
0Antworten
Relevante Empfehlungen
-
Cannot cut round holes
1 Antwort2023-05-12 -
Skipping a basic line
1 Antwort2023-04-25 -
Selection of laser head
0 Antworten04-17 -
Create tabs or slots from a single line
1 Antwort2023-05-25
