G-code words consist of a letter and a value. letter was not found. error

Christian

Kategorien:

Laser

Tags:

LightBurn

395

Übersetzung anzeigen

2023-08-23

Hello, I am getting the following error “g-code words consist of a letter and a value. letter was not found.”, this is my first time trying to engrave an image. I have no idea what to change or do haha

I have a Atezr 35 diode laser, my computer is directly plugged into the laser, have pulled a couple of images to test and get the same error. I have prepped the images in ImagR with a few different settings as well.

Kevin

2023-08-25

I suspect you have “gcode clustering” enabled in Edit->Device Settings. If you see it enabled, disable it and try again.

If it’s not disabled do the following:

1. Push Devices button in Laser window
2. Click on the name of your laser one time
3. Take a screenshot
4. Post screenshot here
5. Take a screenshot of Edit->Device Settings and also post here

Übersetzung anzeigen

Antworten

Relevante Empfehlungen