rdc6563fg + SMC ITV2030

Hi, you can use the multi-meter to test the pressure voltage of the controller. normally it is in the 0~10V.
 So just measure the voltage and the actual air pressure. and then do the linearization between the voltage and the actual pressure in the software

• Pavel_TT

  : I tried doing it in rdworks 3.0. The program does not make changes.

Em qual saida da placa é conectado?

• Rene

  : RDC6563F

• blue sea

  Antworten

  @Rene

  : Hello! RDC6563F motor z-axis interface, pin port PIN24 (orange), signal name ANALOG.