My equipment uses the RDC6332NM control system, which allows for normal cutting. However, when I use the engraving function in RDWorksV8, it does not execute properly. What could be the reason for this? Have I overlooked any settings?
Can you answer this question?
Please write your answer to help those who have this question.
Accepted answerThe 633X series cards are equipped with non-metallic height adjusters, so the engraving function is generally not enabled by default. It is necessary to enable the engraving function in "Manufacturer Parameters=>Special Parameters (Password RDTSMM)" before use.
I think it's an issue with the parameter configuration file, which needs to be matched with the configuration file of your control system model
Have a similar question but can't find a solution? Post your own question and get help from the community.
Copyright © 2021 Shenzhen Chanelink Network Technology Co., Ltd. All Rights Reserved.
Oh, I see. I can use it normally now. Thank you