I used the RDC8445S control system for carving and found that the bottom of the carving was uneven. After careful inspection, I found that this problem occurred in different areas, especially in larger or deeper parts of the carving. I suspect that it is due to insufficient Z-axis accuracy of the engraving machine, or small errors in the stepper motor and transmission system, which prevent stable depth from being maintained during the engraving process. Who can help me solve this problem? Thanks in advance.
Can you answer this question?
Please write your answer to help those who have this question.
Accepted answerI have also encountered this problem before. I found the post I saw before and hope it is helpful to you: https://www.chanelink.com/community/post/co2-cutting-and-engraving-systemlaser-engraving-shows-unevenness-at-the-bottomwhat-should-you-do-3914
Have a similar question but can't find a solution? Post your own question and get help from the community.
Copyright © 2021 Shenzhen Chanelink Network Technology Co., Ltd. All Rights Reserved.
